Furuno FAR-3320W Installation Manual page 49

2. Disconnect the performance monitor connector (J807) from the RF-TB board
3. Unfasten the clamping gland for the serial cable and remove the gasket, flat wash-
ers and protector.
Remove Remove
protector. protector.
Gland for Gland for
antenna cable antenna cable
4. Slide the clamping gland, flat washer, gasket and flat washers in that order onto
the serial cable. Push the flat washer against the armor. Trim the armor so that it
does not extend past the flat washers, then pass the antenna cable through the
cable entrance.
Cable gland Flat washer
Cable gland
Sheath Sheath
Gasket Gasket
Flat washers Flat washers
Flat washer
Flat washer Flat washer
Gasket
Gasket
Outer sheath
Outer sheath
Push the flat washer
against the armor.
Trim the armor.
J807
(performance monitor)
Inner sheath
Inner sheath
2. WIRING
2-13