Furuno FAR-3320W Installation Manual page 67

How to connect the cables
1. Unfasten four screws (M48) to remove the top cover from the processor unit.
2. Unfasten the three bolts circled below to remove the upper plate of the cable
clamp.
J5 J5 J8 J8
J3 J3
J12 J12
J6 J6 J9 J9
J11 J11
J4 J4
J14 J14
J7 J7 J13 J13
J10 J10
Unfasten this bolt to use Unfasten this bolt to use
the lower clamp holes. the lower clamp holes.
Unfasten these three bolts to remove the upper plate.
3. Pass the cables through the clamp holes, then fasten the bolts removed at step 2
to fix the cables.
Processor unit, top view
Clamp holes
(upper)
Clamp holes
(lower)
Lay shields of cables
under this clamp then
tighten the clamp.
2. WIRING
2-31