Furuno FAR-3320W Installation Manual page 75

7. Fabricate the antenna cable as shown below.
RW-00135
See "How to fabricate the LAN cable" on page 28 for how to attach the LAN
cable connector.
Armor Vinyl tape
Sheath Sheath
30
40
8. Pass the antenna cable as shown below through the cable clamp.
9. Connect the power line of the antenna cable to the 13-pin WAGO connector.
1 2 3 4 5
10. Connect the power line and the LAN cable of the antenna cable as shown below.
Connect power line of Connect power line of
antenna cable to TB131 antenna cable to TB131
on PSU-TB Board. on PSU-TB Board.
For retrofit antenna
cable, connect unused
lines here.
170
100
Crimp-on lug (M4)
Wrap the shield of LAN cable
with vinyl tape.
Insert the antenna cable. Insert the antenna cable.
6 7 8 9 10 11 12 13
1 2 3 4 5 6 7 8 9 10 11 12 13
Power line
6
250
100
Crimp-on lug (M3)
Pin Color Pin Color
1
Brown 8 Green
3 Red 9 Blue
6 Orange 11 Purple
7 12
Yellow Gray
Connect LAN cable of
antenna cable to J102
on PSU-CNTL Board.
Ground the LAN
cable.
Clamp the armor.
2. WIRING
LAN cable
Braided
shield
2-39