Furuno FAR-3320W Installation Manual page 52

2. WIRING
3) Unfasten two bolts to remove the RF-TB assembly, then pass the power cable
for the de-icer through the cable entrance.
4) Set the supplied locking wire saddle at location (5) in the figure below. Pass
the cable through locking wire saddles (1) to (5).
5) Unfasten the cable band. Pass the power cable through the band then fasten
the band. Connect the cable to TB901 on the DE-ICER board (03P9573), us-
ing the crimp-on lugs supplied.
2-16
Cable entrance Cable entrance
TB assembly TB assembly
DE-ICER board
(03P9573)
TB901
Cable band Cable band
[TEST] [TEST]
button button
Voltage Voltage
Selection Selection
switch switch