Furuno FAR-3320W Installation Manual page 61

4. Connect the LAN cable to J821. Attach a crimp-on lug to the shield of each cable,
referring to the figure below for the type of crimp-on lug to use. Connect the
shields to the locations shown below. Bind all cables with a cable tie (local supply).
Connect shield of
LAN cable here.
Connect LAN
cable to port J821.
Cable and crimp-on lug to use for shield:
Antenna cable: FV2-4 BLU
LAN cable: FV2-M3 BLU
Serial cable: FV1.25-4(LF) RED
Sub monitor cable: FV5.5-4(LF) YEL
5. Check that armor of cables are lying in their respective cable slots then fasten the
cable clamp.
Microwave coaxial plug
Attach the microwave coaxial plug to the coaxial cable. See the applicable FURUNO
technical information for the procedure. Attach the coaxial cable assy. to the transceiv-
er unit as follows:
1. Unfasten four bolts (M610) to remove the dust cover from the output WG adapt-
er.
2. Fasten eight bolts (removed at step 1) to attach the flange to the transceiver unit.
3. Attach the coaxial cable to the converter of the flange.
Circulator
Transceiver unit, inside view
Adapter
Connect shield of antenna
cable, serial cable here.
M6×10 (4 pcs.)
Output WG
adapter
Flange
2. WIRING
Bind all cables with
locking wire saddle.
Bind all cables with
cable tie (local supply).
Connect shield of sub
monitor cable here.
Coaxial cable
Converter
: M6×20 (8 pcs.)
2-25