Furuno FAR-3320W Installation Manual page 50

2. WIRING
5. Pass the serial cable through the locking wire saddle circled below. Attach the ca-
ble to appropriate WAGO connectors, referring to the interconnection diagram,
then connect them to the RF-TB Board.
- TB802 (motor): 8 pin
- TB803 (signal): 16 pin
- Ground wire: Attach crimp-on lug (FV1.25-3(LF) RED) to wire. Fasten the
crimp-on lug to the chassis with the screw shown below.
TB802
TB803
6. Apply sealant 1211 (supplied as installation material) to the threads of the clamp-
ing gland, and then fasten it tightly with the hook spanner wrench.
Note: Use the wrench of the correct size. If you do not have the hook spanner
wrench, contact your dealer.
7. Coat the O-ring in the gland for the microwave coaxial cable with silicon grease.
Using the supplied waterproofing compound, coat the mating surface between the
coaxial connector of the cable and the waveguide flange on the antenna unit. Do
not coat the O-ring with the waterproofing compound.
2-14
Locking wire saddle Locking wire saddle
for serial cable for serial cable
Coat surface of flange with
waterproofing compound.
Coat surface with
waterproofing
compound.
Coaxial
connector
Fasten ground Fasten ground
wire of serial cable wire of serial cable
with this screw. with this screw.