Mitsubishi Electric AE-200A Service Handbook page 43

[IV Product specifications and functions]
Item
Clear comparison data If an AE-50, EW-50, or PI controller is replaced when using the apportioned electricity billing function,
*5 clear the comparison data of the AE-50/EW-50 or PI controller.
* Comparison data is the data used to compare the latest values on the AE-50/EW-50 and PI
controller with the values on the AE-200 when the previous apportionment was calculated, and
calculate the increment.
Clear carried-over data When the charge time period settings are changed and a unit price in use is changed to unused,
*5 clear the carried-over data for the unit price that was set to unused.
Restore apportioned When the AE-200 is replaced, restore the apportioned data from the AE-50/EW-50 to the new
data *5 AE-200.
Also, when the AE-50/EW-50 is replaced, restore the apportioned data from the AE-200 to the new
AE-50/EW-50.
Touch panel calibration The touch positions of the touch panel can be calibrated.
Software update The software can be updated by either connecting a USB memory device to the AE-200/AE-50 unit
and then operating the LCD screen or by inserting a CD into a PC and then operating the Web
browser.
Group setting The group setting information and interlocked LOSSNAY information are retained even if the power
information and is turned off.
interlocked LOSSNAY
information backup
Error information The error history data is retained even if the power is turned off.
backup
Schedule settings The group schedule information set for each group is retained even if the power is turned off.
backup
Current date and time When the power is turned off, the current time is backed up in an internal capacitor for approximately
backup three days.
(The internal capacitor takes approximately one day to charge. There is no need to replace it.)
Lock function Touch panel operation can be locked to prevent operation until a user name and password are
entered.
Touch panel cleaning The touch panel can be locked and then cleaned.
Time management The clocks on the managed controllers and units are synchronized once a day
(applicable only to controllers and units that support time synchronization).
*1 Refers to LOSSNAY and OA Processing unit.
*2 A separate license is required.
*3 The external input function for emergency stop, ON/OFF, and peak cut level cannot be used with general equipment (DIDO
controller connection).
However, emergency stop input can be used by setting the switch settings of the DIDO controller.
*4 The operation status of general equipment (DIDO controller connection) is not output.
*5 This can be used only when using the AE-200 apportioned electricity billing function.
● The above functions vary depending on the equipment connected and the combination of equipment.
● The above functions are subject to change without notice for improvement.
Description
39
○
○
○
○
○ ○
○
○
○
○
○
○
○