Mitsubishi Electric AE-200A Service Handbook page 105

Hide thumbs Also See for AE-200A:
Table of Contents

Advertisement

[VIII Maintenance]
[Work procedure 2: Updating the AE-200/AE-50]
1.
Procedure using a USB memory device
(1) Check that the update file is correct and then copy it directly below the root folder of a USB memory device.
(2) Log in to the Initial Settings screen and touch [Maintenance] - [Update] in the menu to open the update screen.
(3) Use a hex key to remove the cover and then insert the USB memory device.
For the procedure to remove the cover, refer to "IV [1] 4. How to remove and attach the cover."
(4) Touch [Software Update].
・ The STATUS LED for indicating the status blinks blue during the software update.
・ When the update finishes, the unit restarts.
・ A USB memory device may not be recognized if it is removed and inserted within a short period of time. If that happens, the unit
needs to be reset.
・ If there is a problem with the USB memory device or update file, "The USB memory cannot be recognized normally." or "A data
reading/writing error occurred" appears.
Check the update file and then perform the update again.
If the problem cannot be resolved, replace the USB memory device.
(5) When the AE-200/AE-50 restarts, disconnect the USB memory device and then attach the cover.
(6) Check that the version is the same as the version of the update file.
For how to check the version, refer to "IV [5] How to check the version of AE-200/AE-50/EW-50."
NOTE:
○ Do not disconnect the USB memory device during the update.
101

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ae-200eAe-50eEw-50eEw-50aAe-50a

Table of Contents