Ip Address Settings - Mitsubishi Electric AE-200A Service Handbook

[III System restrictions and notes]

[7] IP address settings

We recommend using the IP addresses in the following table for the AE-200/AE-50/EW-50, TG-2000A, and other equipment when
using a dedicated LAN.
Model
AE-200/EW-50 unit *1
AE-50/EW-50 unit *1
PC for browser
PC for integrated centralized control software
TG-2000A
PLC for Electric Amount Count (PAC-YG11CDA)
PLC for General Equipment (PAC-YG21CDA)
PLC for Demand Input (PAC-YG41CDA)
Router
*1 Set an address within the range of [192.168.1.1] to [192.168.1.40] when using EW-50 individually and within the range of
[192.168.1.211] to [192.168.1.249] when using it as an expansion controller.
Unless otherwise specified, leave the subnet mask of the AE-200/AE-50/EW-50 set to the initial value of [255.255.255.0].
NOTE:
When connecting to an existing LAN, set the IP address and subnet mask specified by the LAN administrator.
The IP address range for various software of PLC differs depending on the model. We recommend using the IP address in the following
table.
Software name
Electric Amount Count PLC
Software
General Control PLC Software
Demand Input PLC Software
[192.168.1.1] to [192.168.1.40]
[192.168.1.211] to [192.168.1.249]
[192.168.1.101] to [192.168.1.149]
[192.168.1.150]
[192.168.1.151] to [192.168.1.170]
[192.168.1.171] to [192.168.1.190]
[192.168.1.191] to [192.168.1.194]
[192.168.1.254]
Model name
PAC-YG11CDA
PAC-YG21CDA
PAC-YG41CDA
21
IP address range
IP addresses
[192.168.1.151] to [192.168.1.155]
[192.168.1.171] to [192.168.1.190]
[192.168.1.191] to [192.168.1.194]