System Menu - Cisco D9040 User And Service Manual

System Menu

Structure
To see the System menu from the Main menu, press the SELECT key.
Each parameter is described in the following. For instructions on how to select and
store settings, see About the Front Panel, page 4-2.
The menu has the following structure:
Status, Alarms
Parameters:
Description:
IP, Management, IP Address
Parameters:
Description:
Important:
IP, Management, Mask
Parameters:
Description:
4020024 Rev C
N/A
A list of active alarms in the system.
<0 to 255>.<0 to 255>.<0 to 255>.<0 to 255>
The IP address of the management interface to the D9040 Encoder.
Contact your local network administrator to obtain an IP address.
Use the numeric keys to type the IP address.
Press the SELECT key to store the entered values.
Press the UP Arrow key to leave the menu.
When you leave the IP menu by pressing the UP Arrow once more
the IP, Mask and Gateway parameters are validated against each
other and stored. Any inconsistencies will be shown in the display.
For the changes to take effect, you must reset the D9040 Encoder
after you have finished setting or changing the IP address, subnet
mask and default gateway. The D9040 Encoder will display a
reminder.
Note: The reset may take up to 120 seconds.
Note: The IP Address is not affected by the Default command.
<0 to 255>.<0 to 255>.<0 to 255>.<0 to 255>
The subnet mask of the management interface to the D9040
Encoder. Setup similar to IP, Management, IP Address, page 4-7,
above.
Note: The subnet mask is not affected by the Default command.
Front Panel Operation 4-7