Cisco D9040 User And Service Manual page 83

Message Description and Remedy
Application file Description: An application code has
downloaded. been downloaded to the encoder. The
system will reboot. Remedy: Wait for the
unit to reboot.
Backup required. Description: Backup is required. One of
the events configured to trigger a backup
event has occurred. Remedy: Look at the
other messages to find the cause of this
event.
Can't enable Description: The installed license file
option as it is not doesn't contain information about the
installed. enabled license. Remedy: Order the
needed license through your local
Cisco technical support
center.
Clock Description: The device failed to fetch the
synchronization clock from the time server. Remedy:
failed. Check the IP address for the clock server
and the IP routing. Also check that the
time server uses the RFC 867 (Day Time
Protocol).
Composite input Description: There is no video source on
loss. the composite video input. Remedy:
Examine the video input selection in the
GUI and check the video source.
Composite Description: The composite video signal
picture sync loss. does not comply with the specifications.
Remedy: Check the input signal
(frequency offset, jitter, etc.).
Dolby Digital: Description: The encoder failed to lock to
AES/EBU audio the audio frame or the audio sample
input error. frequency is out of range. Remedy: Check
the cable and the incoming signal.
Dolby Digital: Description: It is not possible to
Audio delay implement the requested audio delay.
error. Remedy: Decrease the audio data rate or
change video settings to decrease end-to-
end delay. Check relative and external
delay settings.
4020024 Rev C
Service and Maintenance
Severity Default
alarm
category
Information None
Critical None
Information None
Warning None
Major A
Major B
Major B
Major B
Enable
On
On
On
On
On
On
On
On
5-9