Connecting The Audio Inputs - Cisco D9040 User And Service Manual

Connecting the Audio Inputs

Connectors for the Audio Input
The basic configuration of the D9040 Encoder supports two stereo channels.
Optionally it supports two additional stereo channels.
Digital audio for channels 1 and 2 is input at the BNC connector called Digital
Audio In.
The following drawing shows the two BNC connectors:
The connector label Analog Audio In 1 & 2 denotes that analog audio for channels 1
and 2 is input at the top row of pins on the terminal block connector.
The connector label Ana/Dig Audio In 3 & 4 denotes that analog or digital audio for
channels 3 and 4 is input at the bottom row of pins on the terminal block connector.
On the PNC, you can set up the D9040 Encoder to use either the analog or the
digital stereo channels. The D9040 Encoder also supports encoding of audio
embedded in the SDI video signal.
The following drawing shows the pin positions of the terminal block connector:
3-8 Installation
4020024 Rev C