Cisco D9040 User And Service Manual page 30

Connecting the Units,
7. If relevant, connect the external contact closure equipment or cue tone
equipment to the contact closure interface of the D9040 Encoder. For further
information, see Connecting to the Contact Closure or Cue Tone Interfaces,
page 3-12.
8. Connect the ETHERNET 10/100 BASE-T MANAGEMENT connector of the
D9040 Encoders to the Ethernet LAN of the PNC control system.
Use a shielded Cat. 5 (or better) ethernet cable. For further information, see
Connecting the Ethernet Management Interface, page 3-15.
9. Connect the output signals from the D9040 Encoder connectors ASI OUT 1 and/
or ASI OUT2 to the ASI input connectors of the equipment after the D9040
Encoder.
The equipment after the D9040 Encoder will typically be a PowerVu Model
D9140 Advanced Multiplexer.
10. If relevant, connect the output signals from the D9040 Encoder connectors ASI
MONITOR to an ASI monitor decoder.
11. Connect the power sources of all the units.
For further information, see the specific product manuals in question. When
connecting the power source to the D9040 Encoder it takes up to 120 seconds for
the unit to initialize. The front panel display shows the startup display.
1-2
Continued
Quick Setup - Read Me First!
4020024 Rev C