Cisco D9040 User And Service Manual page 87

Message Description and Remedy
Layer II: AES/ Description: The encoder failed to lock to
EBU audio input the audio frame or the audio sample
error. frequency is out of range. Remedy: Check
the cable and the incoming signal.
Layer II: Audio Description: It is not possible to
delay error. implement the requested audio delay.
Remedy: Decrease the audio data rate or
change video settings to decrease end-to-
end delay. Check relative and external
delay settings.
Layer II: DSP Description: The audio delay setup on the
Delay high error Audio DSP is too high. Remedy: Decrease
the audio delay.
Layer II: DSP Description: The audio delay setup on the
Delay low error. Audio DSP is too low. Remedy: Increase
the audio delay.
Layer II: Description: The encoder failed to lock to
Embedded audio the embedded audio. Remedy: Check that
not locked. the audio channels are embedded where
required. Check the sources of the
embedded audio.
Layer II: Description: The audio input signal is
Overload on the overloaded. The audio input level has
audio input reached the clipping level. Remedy:
signal. Increase the clipping level or reduce the
input level.
Layer II: PCR rate Description: The requested PCR rate
error. cannot be achieved. Remedy: No action
possible.
Layer II: TS rate/ Description: The encoding rate is too high
audio rate compared to the TS rate or the encoding
mismatch. rate is too low. The encoding will restart.
Remedy: Check the settings. Change the
audio encoding rate or increase the TS
rate. If a FIFO error occurs recurrently,
contact your Cisco technical support
center.
4020024 Rev C
Service and Maintenance
Severity Default
alarm
category
Major B
Major B
Minor None
Major B
Major B
Minor B
Minor None
Major B
Enable
On
On
On
On
On
On
On
On
5-13