Control And Management Interfaces - Cisco D9040 User And Service Manual

Control and Management Interfaces

PNC Control System Management
The PNC is a single-server/multi-client based system enabling you to set up and
manage a whole network of encoders. In the PNC multi-user system, the server and
client are located on separate PCs. The PNC enables full control and monitoring
functionality of the D9040 Encoder installations with redundancy switching, error
reporting and remote control. Refer to the PowerVu Network Centre Control
System v8.0 User's Guide (part number 4018881 Rev A) for more information.
Front Panel Control
There is limited control available via the front panel. You can only set or change the
encoder IP address, lock or unlock the front panel, and monitor the alarm status.
The following drawing shows the front panel with its different sections.
Ethernet
The main control interface for the D9040 Encoder is the 10/100 BaseT Ethernet
interface.
You can set up and control the D9040 Encoder via the Ethernet connection using
SNMP and the PNC control system.
4020024 Rev C
Alarm LED
LCD Panel
Power LED
Navigation/
Selection Keypad
Numeric Keypad
Introduction 2-11