Replacing An Ac Fuse In The Power Supply - Cisco D9040 User And Service Manual

Replacing an AC Fuse in the Power Supply

To Replace an AC Fuse
To replace an AC fuse do the following:
1. Turn off the power to the D9040 Encoder.
2. Remove the power cord from the D9040 Encoder.
3. Open the lid holding the fuses.
Use a flat bladed screwdriver.
Note: There is a fuse in both phase conductors.
4. Pull out the lid.
5. Remove the blown fuse(s).
6. Insert a new fuse with the same rating.
The fuse rating for the D9040 Encoder is 2 AT.
For continued protection against risk of fire replace only with same type and
rating of fuse.
7. Reinsert the lid.
5-6
CAUTION:
Service and Maintenance
98-017
4020024 Rev C