Cisco D9040 User And Service Manual page 86

Message Description and Remedy
DPI Transport Description: Data were lost when
packet overflow. attempting to load a DPI message to the
buffer. Remedy: Increase the DPI bit rate.
EDH error: EDH Description: The EDH (Error Detected
flag activated in Here) flag was activated in the encoder
encoder. for one of the three groups (ANC/AP/
FF). Remedy: Check your SDI source and
the equipment that generates EDH.
EDH input loss. Description: The EDH signal has
disappeared. The encoder receives no
EDH data. Remedy: Check your SDI
source and the equipment that generates
EDH.
Encoding Description: The internal MPEG
processing error. processing of the encoder failed. The
encoding will restart. Remedy: Check
your settings for parameter violations.
Observe the limitations in the manual. If
persistent, contact your Cisco
technical support center for further
assistance.
Fan malfunction. Description: The system has detected a
fan malfunction. Remedy: Replace the fan
if it is not working correctly.
Front panel Description: Settings in the device can
unlocked. now be changed via the front panel.
Remedy: Not applicable.
Invalid system Description: The detected system type
type detected. does not comply with the system type
setting in the encoder. Remedy: Apply a
correct system type (525 or 625 lines) or
change the Video Input Type in the
encoder.
IP streaming Description: Internal buffer for IP
buffer full. streaming has been overwritten. TS
packets have been lost and picture quality
is degraded. Remedy: Lower the ASI
output bit rate or check that the video IP
network is not overloaded.
5-12 Service and Maintenance
Severity Default
alarm
category
Major None
Minor None
Major None
Major B
Critical A
Warning None
Major A
Major B
4020024 Rev C
Enable
On
Off
Off
On
On
On
On
On