Cisco D9040 User And Service Manual page 85

Message Description and Remedy
Dolby Digital: Description: The incoming bit rate on
Passthrough rate passthrough is lower than the setting.
low. Remedy: Increase the selected bit rate.
Dolby Digital: Description: The incoming bit rate on
Passthrough rate passthrough is too high. Remedy: No
too high. action needed.
Dolby Digital: Description: The requested PCR rate can
PCR Rate error. non be achieved Remedy: No action
possible.
Dolby Digital: TS Description: The encoding rate is too high
rate/audio rate compared to the TS rate, or the encoding
mismatch. rate is too low. The encoding will restart.
Remedy: Check the settings. Change the
audio encoding rate or increase the TS
rate. If a FIFO error occurs recurrently,
contact your Cisco technical support
center.
DPI Cancel Description: An external control signal
triggered without occurred out of sequence. A Start
associated Start. command must be triggered before it can
be canceled. Remedy: Setup of
automation system may need to be
corrected.
DPI Message Description: The general purpose input
trigger ignored detected multiple triggers too close
due to debounce together in time. Remedy: Reduce the
delay. debounce delay setting, or increase the
time between triggers or provide
debounce protection to the general
purpose input.
DPI PTS delay Description: The relative delay setting has
invalid. made the splice_time() PTS value to
reference a point in time that has already
occurred. Remedy: Change relative delay
parameters.
DPI Stop Description: An external control signal
triggered without occurred out of sequence. A Start
associated Start. command must be triggered before it can
be stopped. Remedy: Setup of automation
system may need to be corrected.
4020024 Rev C
Service and Maintenance
Severity Default
alarm
category
Minor None
Major B
Minor None
Major B
Minor None
Minor None
Major None
Minor None
Enable
On
On
On
On
On
On
On
On
5-11