Sensor Characteristics; Reset Mode; Service Mode - Siemens SITRANS F MAG 6000 I Operating Instructions Manual

7.4

Sensor characteristics

The sensor characteristics menu shows:
● If a SENSORPROM
● Suppress error P 40 (SENSORPROM
● Sensor size
● Calibration factor
● Correction factor
● Excitation
See also sensor characteristics menu diagram (Page 81).
7.5

Reset mode

The reset mode is used for resetting/presetting totalizers or for restoring the factory settings.
Resetting
1. Press top up key
2. Enter password.
3. Use forward key
4. Press lock/unlock key
5. Press forward key
6. Press lock/unlock key
If restoring of factory settings (Page 89) is required:
1. Press lock/unlock key
See also reset menu diagram (Page 82).
7.6

Service mode

All outputs of the transmitter can be forced-controlled in the service mode menu, see also
service mode menu diagram (Page 83).
It is possible to check whether the outputs are functioning.
Error pending and status log lists are also accessible from this menu and the operating time
(in days) can be read.
The forced control is stopped and all previous settings are reinitialized the moment the
service mode is left by pressing top up key
MAG 6000 I / MAG 6000 I Ex de transmitter
Operating Instructions, 04/2016, A5E02083319-AG
is installed or not
®
not installed)
®
for 2 sec.
or backward key to reach reset mode menu.
to enter reset menu.
to reach totalizer to be reset or default setting menu.
to start resetting.
again to confirm destruction of customized settings.
7.4 Sensor characteristics
.
Functions
49