Bareshaft Rv Pumps; Description; Fit The Motor To The Bareshaft Pump - Edwards RV3 Instruction Manual

Rotary vane pumps
Hide thumbs Also See for RV3:
Table of Contents

Advertisement

9

Bareshaft RV pumps

9.1

Description

Two types of bareshaft pump are available:
To suit an IEC72–1 motor with an (IMB14) FT85 face mounting and 14 mm diameter shaft.
To suit a NEMA 56C motor with a
The motor you will fit must have a power rating which is adequate for use with the RV pump: refer to the pump
electrical data section in the manual.
Note:
The performance data given in
bareshaft pump, the performance may be affected by the type of motor fitted.
9.2

Fit the motor to the bareshaft pump

1. Refer to
Figure
11. Use the four screws (455) to fit the motor support (453) to the motor.
2. Use the two screws (422) to fit the lifting plate (413), then fit the lifting plate cover (414).
3. Fit the fan ducting sheet (409).
4. Ensure that key 'B' is in place on the motor shaft, then push the fan (410) onto the shaft. Ensure that:
The end of the shaft aligns with the bottom of the cavity in the fan.
The back of the fan is 2.5 mm from the ducting sheet.
5. Secure the fan to the shaft with the screw (454): tighten the screw to a torque between 7 and 9 Nm.
6. Use a suitable lubricant on the coupling element (411) then fit the element to the coupling hub.
7. Align the coupling element in the hub with the coupling in the fan and fit the motor to the pump.
8. Secure the motor with the four screws (421). Tighten the screws to a torque of between 10 and 12 Nm. Note
that:
The gap between the coupling faces must be 2 mm or less.
If necessary, adjust the position of the coupling hub on the pump shaft so that the gap is correct.
© Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trade marks of Edwards Limited.
5
/
inch diameter shaft.
8
Section 2
applies to pumps supplied with a motor fitted as standard. On a
A652–01–880 Issue S
Page 51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rv5Rv8Rv12

Table of Contents