Accessories; Introduction; Inlet Catchpot; Inlet Dust Filter - Edwards RV3 Instruction Manual

7.4

Accessories

7.4.1

Introduction

The accessories which can be fitted to the RV pump are shown in
Table 14.
These accessories are briefly described in Sections 7.4.2 to 7.4.14.
Accessory
ITO20K Inlet catchpot
ITF20K Inlet dust filter
ITD20K Inlet desiccant trap
ITC20K Inlet chemical trap
FL20K Foreline trap
EMF10 Outlet mist filter
EMF20 Outlet mist filter
Gas-ballast adaptor
Gravity oil drain kit
Oil drain-extension
Exhaust nozzle kit
Vibration isolators (pack of four)
EBV20 Solenoid Operated Gas-Ballast Valve
220–240 V 50/60 Hz
100–120 V 50/60 Hz
PV25EK Pipeline Valve (aluminium)
220–240 V 50/60 Hz
110–127 V 50/60 Hz
PV25EK Pipeline Valve (stainless steel)
220–240 V 50/60 Hz
110–127 V 50/60 Hz
7.4.2

Inlet catchpot

The inlet catchpot traps any liquid droplets and prevents their entry into the pump.
7.4.3

Inlet dust filter

The inlet dust filter protects the pump against abrasive dust.
7.4.4

Inlet desiccant trap

Use a desiccant trap when you pump limited quantities of water vapour at high pumping speeds to a low vapour
pressure.
© Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trade marks of Edwards Limited.
Table 14 - Accessory Item Numbers
Figure 10, and their Item Numbers are listed in
Refer to Section
7.4.2
7.4.3
7.4.4
7.4.5
7.4.6
7.4.7
7.4.7
7.4.8
7.4.9
7.4.10
7.4.11
7.4.12
7.4.13
7.4.14
7.4.14
A652–01–880 Issue S
Item Number
A441–10–000
A442–15–000
A445–10–000
A444–10–000
A133–05–000
A462–26–000
A462–29–000
A505–02–000
A505–01–000
A505–03–000
A505–09–000
A248–01–404
A500–06–930
A500–06–984
C413–01–000
C413–03–000
C413–02–000
C413–04–000
Page 45