Top Link; Stabilizer - Kubota M5N-091 Operator's Manual

64 3-POINT HITCH & DRAWBAR
BTop Link
1. Adjust the angle of the implement to the desired
position by shortening or lengthening the top link.
2. The proper length of the top link varies according to
the type of implement being used.

(1) Top link

A The length of the screw at both ends of the top link
must be the same always.
(A) "Length of the screw"
BStabilizer
The stabilizer is used to adjust the lower link width.
Rotate the turnbuckle to adjust the stabilizer length.
When adjusting, make sure both the stabilizers are equal
in overall length.
C Turnbuckle locked position
After adjusting the stabilizer length, the turnbuckle must
remain in the locked position.
(1) Turnbuckle
(2) Set-pin
(3) Hex wrench handle

(4) Stabilizer