Kubota M5N-091 Operator's Manual page 95

C Flow control
The remote control valve with flow control may be added
for the following purposes.
1. The attachments that are connected with the auxiliary
control valve can be independently adjusted for flow
rate.
2. To operate within limits, the remote control valves (1)
and/or (2) and the 3-point hitch at the same time
without one affecting the other.
3. To maintain within limits, the constant speed of an
attachment (hydraulic motor RPM, for example) when
connected to the remote control valves (1) and/or (2).
A At slower engine speeds the total hydraulic flow rate
may be inadequate for simultaneous operation of the
remote control valves (1) and/or (2) and the 3-point
hitch, or operation of an attachment connected to the
remote control valves (1)(2). Under these conditions,
the engine speed must be increased to provide
additional hydraulic flow.
(1) Remote control valve (1) with flow control
(2) Remote control valve (2) with flow control
(3) Flow control knob for valve (1)
(4) Flow control knob for valve (2)
C Adjusting the flow rate
1. The flow rate for the remote control valves (1) and (2)
can be adjusted.
2. Turn the flow control
counterclockwise (A), and the flow rate for the remote
control valves (1) and/or (2) increases. A clockwise
turn (B) of the knob causes the flow to decrease. If the
knob is turned all the way (C), there will be no flow.
3. To adjust the flow rate, set the engine speed to the
operating RPM, turn the flow control knob once all the
way clockwise (C), and then turn it gradually
counterclockwise until a required flow rate is reached.
A Oil from the pump flows by priority to the auxiliary
control valve. Surplus oil is fed to the 3-point hitch.
With the auxiliary control valve at neutral, the total flow
from the pump is fed to the 3-point hitch.
A When there is no need to adjust the flow rate, turn the
flow control knob all the way counterclockwise and
keep it in this position.
(1) Remote control valve (1) with flow control
(2) Remote control valve (2) with flow control
(3) Flow control knob for valve (1)
(4) Flow control knob for valve (2)
HYDRAULIC UNIT
knobs (3) and/or
(A) "INCREASE"
(B) "DECREASE"
(C) "STOP"
71
(4)