3-Point Hitch; Selecting The Holes Of Lower Links; Selecting The Top Link Mounting Holes; Drawbar - Kubota M5N-091 Operator's Manual

62 3-POINT HITCH & DRAWBAR

3-POINT HITCH

1. Make preparations for attaching
implement.
BSelecting the holes of Lower Links
There are 2 holes in the lower links. For most operations
the lifting rods should be attached to the (B) hole.
(1) Lower link (4) Nut
(2) Lifting rod (5) Lift rod pin
(3) Split pin (6) Thrust collar
A The lifting rods may be attached to (A) for greater
lifting force.
A Install the thrust collar in the outside of the lower link.
A Tighten the nut by hand and fix the nut with the cotter
pin.
BSelecting the Top Link Mounting Holes
Select the proper set of holes by referring to the
"Hydraulic Control Unit Use Reference Chart" in Hydraulic
Unit section.
If the hydraulic unit is set for draft control, draft response
is more sensitive when an implement is connected to the
lower set of top link mounting holes. If draft control is not
required, it is recommended to use the top set (1).
holes: (A), (B)
BDrawbar
Remove the drawbar if a close mounted implement is
attached.