Checking Water Separator; Checking Engine Oil Level - Kubota M5N-091 Operator's Manual

96 PERIODIC SERVICE
BChecking Water Separator
1. When the water has collected upper limit in the water
separator, the water separator indicator on the
instrument panel lights up and warning buzzer
sounding.
(1) Water separator indicator
2. In such case, close the fuel shutoff-valve and loosen
the air plug and drain plug by several turns.
3. Allow water to drain. When no more water comes out
and fuel starts to flow out, retighten the air plug and
drain plug.
4. Bleed the fuel system.
(See "SERVICE AS REQUIRED" in "PERIODIC
SERVICE" section.)
(1) Red float
(2) Fuel shutoff-valve
(3) Air plug
(4) Cup
(5) Drain plug
A When the red float reaches near the upper limit level,
start from step 2 in the above procedure to drain water
in the water separator.
A If water is drawn through to the fuel pump, extensive
damage will occur.
(A) "ON"
(B) "OFF"
(C) "FUEL"
(D) "UPPER LIMIT"
(E) "WATER"
BChecking Engine Oil Level
To avoid personal injury or death:
A Be sure to stop the engine before checking the
oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the engine or 5
minutes or more after the engine has stopped.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the 2 notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Oil inlet (A) Oil level is acceptable within this range.
(2) Dipstick
A When using an oil of different maker or viscosity from
the previous one, remove all of the old oil.
Never mix two different types of oil.
A If oil level is low, do not run engine.