Bleeding Brake System; Draining Clutch Housing Water - Kubota M5N-091 Operator's Manual

2. Disconnect the heater connector.
(1) Connector
A Do not try air-bleeding with the heater in operation.
Otherwise the battery may get damaged.
3. Turn ON and OFF the key switch repeatedly 10 times
or so at the following intervals. This lets the air out of
the fuel line.
(1) Key switch ON time: 30 seconds
(2) Key switch OFF time: 15 seconds
(1) Key switch
4. Connect the heater connector.
(A) "ON"
(B) "OFF"
5. Set the hand throttle lever at the maximum speed
position, turn the key switch to start the engine and
then reset the throttle lever at the mid speed (around
1500 rpm) position.
If engine doesn't start, try it several times at 30 second
intervals.
A Do not hold key switch at engine start position for more
than 10 seconds continuously. If more engine cranking
is needed, try again after 30 seconds.
6. Accelerate the engine to remove the small portion of
air left in the fuel system.
7. If air still remains and the engine stops, repeat the
above steps.
BBleeding Brake System
Consult your local KUBOTA Dealer for this service.
BDraining Clutch Housing Water
The tractor is equipped with a drain plug under the clutch
housing.
After operating in rain, snow or if the tractor has been
washed, water may get into the clutch housing.
Remove the drain plug and drain the water, then install the
plug again.
PERIODIC SERVICE 127