Kubota M5N-091 Operator's Manual page 89

C Turnbuckle unlocked position
1. Lift the set-pin and slide the hex wrench handle
forward.
(1) Set-pin
(2) Hex wrench handle
2. Lower the set-pin and make sure the hex wrench
handle cannot move past the set-pin tip.
(1) Set-pin
(2) Hex wrench handle
(A) "Lift"
(B) "Slide forward"
3-POINT HITCH & DRAWBAR
C Rotating the turnbuckle
1. Use the hexagonal part of the wrench and the hex
wrench handle to rotate the turnbuckle once.
2. Slide the hex wrench handle forward to release it from
the turnbuckle.
3. Rotate the hex wrench handle and slide it backward
until the hexagonal part is locked on the turnbuckle.
4. Repeat steps 1 to 3 until the desired stabilizer length
is achieved.
Rotating
clockwise
Counterclockwise
[Example: Turnbuckle (RH) counterclockwise]
(1) Hexagonal part
(2) Turnbuckle
(3) Hex wrench handle
A Adjusting the left hand side stabilizer is done the same
way as for the right hand side stabilizer.
Stabilizer Lower link
length width
Shorten Widen
Lengthen Narrow
(A) "Rotate"
(B) "Slide forward"
(C) "Slide backward"
65