Checking Power Steering Line - Kubota M5N-091 Operator's Manual

6. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
7. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the dipstick.
(1) Gauge (A) Oil level is acceptable within this range.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid doesn't leak pass
the seal on the filter.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
BChecking Power Steering Line
1. Check to see that all lines and hose clamps are tight
and not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
(1) Power steering pressure hoses
PERIODIC SERVICE 115