Replacing Engine Oil Filter - Kubota M5N-091 Operator's Manual

(1) Drain plug
BReplacing Engine Oil Filter
To avoid personal injury or death:
A Be sure to stop the engine before replacing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
(1) Engine oil filter
A To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
PERIODIC SERVICE 113