3-Point Hitch; Make Preparations For Attaching Implement; Selecting The Holes Of Lifting Rods And Lower Links; Selecting The Top Link Mounting Holes - Kubota B2401DT Operator's Manual

3-POINT HITCH

3-POINT HITCH
1. Make preparations for attaching
implement
1.1 Selecting the holes of lifting rods and
lower links
There are 2 holes in the lower links. For most
operations, the lifting rods should be attached to the (A)
holes.
(1) Lower links
(2) Lifting rods
NOTE :
• The lifting rods may be attached to (B) hole for
higher lifting height (with reduced lifting force).

1.2 Selecting the top link mounting holes

1. Select the proper set of holes by referring to
Hydraulic control unit use reference chart on page
49.
(1) Mounting hole 1

1.3 Drawbar

Remove the drawbar if a close mounted implement is
being attached.
B2401DT, B2401DTWO, B2401DTN
(A) Hole
(B) Hole
(2) Mounting hole 2
3-POINT HITCH AND DRAWBAR
2. Attaching and detaching
implements
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the key.
• Do not stand between tractor and implement
unless parking brake is applied.
• Before attaching or detaching implement, locate
the tractor and implement on a firm, flat and
level surface.
• Whenever an implement or other attachment is
connected to the tractor 3-point hitch, check full
range of operation for interference, binding or
PTO driveline separation.

2.1 Lifting rod (right)

1. Level a 3-point mounted implement from side to
side by turning the adjusting handle to shorten or
lengthen the adjustable
implement on the ground.
2. After adjustment, tighten the lock nut securely.
(1) Adjusting handle

2.2 Top link

1. Adjust the angle of the implement to the desired
position by shortening or lengthening the top link.
The proper length of the top link varies according to
the type of implement being used.

2.3 Telescopic stabilizers

Adjust the telescopic stabilizers to control horizontal
sway of the implement. Select the proper set of holes
by referring to Hydraulic control unit use reference
chart on page 49.
After aligning satisfactorily, insert the set-pin through
any one of the 8 holes on the outer tube that align with
lifting rod with the
(2) Lock nut
43