Table of Contents
Advertisement
30
OPERATING THE ENGINE
7. Fully depress the clutch pedal.
8. Turn the key to "START" position and
release when the engine starts.
A Because of the safety devices, the engine will not start
except when the PTO clutch control switch is placed in
the "OFF" position and shuttle shift lever is placed in
the "NEUTRAL" position.
9. Check to see that all the indicators on
the Easy Checker(TM) are "OFF".
If an indicator is still on, immediately stop the engine and
determine the cause.
10. Release the clutch pedal.
COLD WEATHER STARTING
If the ambient temperature is below 0
engine is very cold, follow the procedure below after
taking the step 1 through 5 in the previous pages.
6. Turn the key to "ON" position and hold
it until the heater indicator turns off.
Heater indicator comes on when the key is turned to "ON"
position and engine coolant temperature is below 0
(32
), and goes off automatically when preheat is
completed.
(1) Heater indicator
7.
Fully depress the clutch pedal.
8.
Turn the key to the "START" position
and the engine should start.
(If the engine fails to start after 10 seconds, turn off the
key for 30 seconds. Then repeat steps 6 through 8. To
protect the battery and the starter, make sure that the
starter is not continuously turned for more than 10
seconds.)
BBlock Heater (if equipped)
A block heater is available as an option from your dealer.
It will assist you in starting your tractor when the ambient
temperature is below -20
(32
) and the
(-4
).
Advertisement
Table of Contents
Troubleshooting
