Table of Contents
Advertisement
42
OPERATING THE TRACTOR
BClutch Off Switch
[Dual speed model]
To avoid personal injury or death:
A If you release the clutch off switch when the
travel speed is selected, the clutch becomes
engaged and the tractor will begin to move.
A Always use the clutch pedal to start the tractor.
The clutch off switch can be shifted a gear without using
the clutch pedal.
While pressing the clutch off switch, the clutch is
disengaged.
When releasing the clutch off switch, the clutch is
engaged.
(As if to shift the shuttle shift lever from N to F (or R),
clutch is engaged by modulate.)
A While pressing the clutch off switch, position display of
the shuttle shift lever on the LCD monitor is flashed.
(1) Clutch off switch
(A) "FLASH"
BCreep Speed (if equipped)
Shift the range gear shift lever to
speeds.
This shifting requires clutch operation.
(1) Range gear shift lever
C Creep speed should be used only when doing one
of the following jobs:
1. Deep rotary-tilling and harrowing
2. Planting
3. Turf application
C Creep speed can not be used for any of the
followings:
1. Pulling a trailer
2. Front-loader operation
3. Front-blade operation
4. Earth-moving
5. Entering and leaving a field
6. Loading onto and unloading from a truck
To avoid personal injury or death:
A When you leave the tractor, be sure to apply the
parking brake and stop the engine.
A IN APPLYING THE BRAKES:
A The torque of the wheel axle is extremely
high while creep speed is being used. Be
sure to step down on the clutch pedal
completely before applying the brakes, or
they will not work
A When starting to operate the tractor, be sure
to release the parking brakes.
Misuse of the brakes may cause damage to
the transmission and is therefore not
acceptable to KUBOTA for coverage under
the warranty.
A Press the clutch pedal completely down and stop the
tractor's motion before shifting the range gear shift
lever.
to obtain low
...Creep ON
Advertisement
Table of Contents
Troubleshooting
