Qinq Configuration Examples; Basic Qinq Configuration Example - HP 5820X series Configuration Manual

For more information about customer-side QinQ, see the chapter "VLAN mapping configuration."
SVLAN TPID and QinQ cannot both be configured on a port at the same time.

QinQ configuration examples

Basic QinQ configuration example

Network requirements
As shown in Figure
Provider A and Provider B are edge switches on the service provider network and are interconnected
•
through trunk ports. They belong to SVLAN 10 and 50.
Customer A1, Customer A2, Customer B1 and Customer B2 are edge switches on the customer
•
network.
Third-party switches with a TPID value of 0x8200 are deployed between Provider A and Provider B.
•
Make configuration to satisfy the following requirements:
Frames of VLAN 200 through VLAN 299 can be exchanged between Customer A1 and Customer
•
A2 through VLAN 10 of the service provider network.
Frames of VLAN 250 through VLAN 350 can be exchanged between Customer B1 and Customer
•
B2 through VLAN 50 of the service provider network.
Figure 56 Network diagram for basic QinQ configuration
Configuration procedure
Make sure that the switches in the service provider network have been configured to allow QinQ packets
to pass through.
Configuration on Provider A
1.
Configure GigabitEthernet 1/0/1
•
# Configure VLAN 10 as the default VLAN of GigabitEthernet 1/0/1.
<ProviderA> system-view
[ProviderA] interface gigabitethernet 1/0/1
56,
171