Gvrp Fixed Registration Mode Configuration Example - HP 5820X series Configuration Manual

[DeviceB-vlan3] quit
Verify the configuration
3.
Use the display gvrp local-vlan command to display the local VLAN information maintained by GVRP on
ports. For example:
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 1/0/1 of Device A.
[DeviceA] display gvrp local-vlan interface gigabitethernet 1/0/1
Following VLANs exist in GVRP local database:
1(default),2-3
According to the output, information about VLAN 1, static VLAN information of VLAN 2 on the local
device, and dynamic VLAN information of VLAN 3 on Device B are all registered through GVRP.
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 1/0/1 of Device B.
[DeviceB] display gvrp local-vlan interface gigabitethernet 1/0/1
Following VLANs exist in GVRP local database:
1(default),2-3
According to the output, information about VLAN 1, static VLAN information of VLAN 3 on the local
device, and dynamic VLAN information of VLAN 2 on Device A are all registered through GVRP.

GVRP fixed registration mode configuration example

Network requirements
As shown in Figure
Device A and Device B are connected through their GigabitEthernet 1/0/1 ports.
•
Enable GVRP and configure the fixed registration mode on ports to enable the registration and
•
deregistration of static VLAN information between the two devices.
Figure 51 Network diagram for GVRP fixed registration mode configuration
Configuration procedure
Configure Device A
1.
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port GigabitEthernet 1/0/1 as a trunk port, and assign it to all VLANs.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-type trunk
[DeviceA-GigabitEthernet1/0/1] port trunk permit vlan all
# Enable GVRP on GigabitEthernet 1/0/1 and set the GVRP registration mode to fixed on the port.
[DeviceA-GigabitEthernet1/0/1] gvrp
[DeviceA-GigabitEthernet1/0/1] gvrp registration fixed
[DeviceA-GigabitEthernet1/0/1] quit
# Create VLAN 2 (a static VLAN).
51,
157