HP 5820X series Configuration Manual page 175

Copying the 802.1p priority in the inner VLAN tags to the outer VLAN tags.
•
If you set the trusted packet priority type to 802.1p priority on a port with QinQ or selective QinQ
enabled, the port automatically copies the 802.1p priority from the inner VLAN tag to the outer VLAN tag
when adding the outer VLAN tag to each packet. For more information about the trusted packet priority
type, see the ACL and QoS Configuration Guide.
To mark the 802.1p priorities in outer VLAN tags according to the inner VLAN IDs or the 802.1p priorities
in the inner VLAN tags:
To do...
1. Enter system view
Create a class and enter class
2.
view
Configure a
match criterion
to match the
specified inner
VLAN IDs
3. Configure
a match
Configure a
criterion
match criterion
to match the
specified inner
VLAN tag
priorities
4. Return to system view
5. Create a traffic behavior and
enter traffic behavior view
Configure the
action of
marking the
802.1p
priorities in
6. Configure
outer VLAN
the action
tags
of
specifying
Configure the
the outer
action of
VLAN tag
copying the
priorities of
802.1p
packets
priorities in the
inner VLAN
tags to the
outer VLAN
tags
7. Return to system view
8. Create a QoS policy and
enter QoS policy view
9. Associate the traffic class with
the traffic behavior defined
earlier
Use the command...
system-view
traffic classifier classifier-name
[ operator { and | or } ]
if-match customer-vlan-id vlan-id-
list
if-match customer-dot1p 8021p-
list
quit
traffic behavior behavior-name
remark dot1p 8021p
remark dot1p customer-dot1p-
trust
quit
qos policy policy-name
classifier classifier-name behavior
behavior-name
168
Remarks
—
Required.
By default, the operator of a class
is AND.
Use either command.
—
Required.
Use either command.
Choose to configure inner-outer
VLAN 802.1p priority mapping
or copying as needed.
—
Required.
Required.