Configuring An Inner-Outer Vlan 802.1P Priority Mapping - HP 5820X series Configuration Manual

To configure selective QinQ:
To do...
1. Enter system view
2. Create a class and enter class
view
3. Specify the inner VLAN IDs of
matching frames
4. Return to system view
5. Create a traffic behavior and
enter traffic behavior view
6. Specify an outer VLAN ID
7. Return to system view
8. Create a QoS policy and
enter QoS policy view
9. Associate the traffic class with
the traffic behavior defined
earlier
10. Return to system view
11. Enter the
Ethernet
port view
of the
customer
network-
side port
12. Enable basic QinQ
13. Apply the QoS policy to the
incoming traffic
CAUTION:
Selective QinQ enjoys higher priority than basic QinQ. A received frame is tagged with an outer
•
VLAN ID based on basic QinQ only after it fails to match the match criteria defined in the traffic
class.
Selective QinQ is achieved through QoS policies. For more information about QoS policies, see the
•
ACL and QoS Configuration Guide

Configuring an inner-outer VLAN 802.1p priority mapping

The HP 5800&5820X switches series achieve the following inner-outer VLAN 802.1p priority mapping
modes through QoS policies:
Marking the 802.1p priorities in outer VLAN tags according to the inner VLAN IDs or the 802.1p
•
priorities in the inner VLAN tags.
Use the command...
system-view
traffic classifier classifier-name
[ operator { and | or } ]
if-match customer-vlan-id vlan-id-
list
quit
traffic behavior behavior-name
nest top-most vlan-id vlan-id
quit
qos policy policy-name
classifier classifier-name behavior
behavior-name
quit
Enter Layer 2
interface interface-type interface-
Ethernet
number
interface view
Enter port group port-group manual port-group-
view name
qinq enable
qos apply policy policy-name
inbound
.
167
Remarks
—
Required.
By default, the operator of a class
is AND.
Required.
—
Required.
Required.
—
Required.
Required.
—
Required.
Use either command.
• Settings made in Layer 2
Ethernet interface view take
effect only on the current port.
• Settings made in port group
view take effect on all ports in
the port group.
Required.
Required.