HP 5820X series Configuration Manual page 191

To do...
3. Configure an SVLAN as the
match criterion
4. Return to system view
5. Create a traffic behavior and
enter traffic behavior view
6. Configure a CVLAN marking
action
7. Return to system view
8. Create a QoS policy and
enter QoS policy view
9. Associate the class with the
behavior to map the SVLAN
to the CVLAN
Configuring the customer-side port
To configure the customer-side port:
To do...
1. Enter system view
2. Enter Layer 2 Ethernet
interface view
3. Configure the port as a trunk
port
4. Assign the port to CVLANs
and SVLANs
5. Enable basic QinQ
6. Apply the uplink policy to the
incoming traffic
7. Apply the downlink policy to
the outgoing traffic
Configuring the network-side port
To configure the network-side port:
To do...
1. Enter system view
2. Enter Layer 2 Ethernet interface view
Use the command...
if-match service-vlan-id vlan-id
quit
traffic behavior behavior-name
remark customer-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
Use the command...
system-view
interface interface-type interface-
number
port link-type trunk
port trunk permit vlan { vlan-id-list
| all }
qinq enable
qos apply policy policy-name
inbound
qos apply policy policy-name
outbound
Use the command...
system-view
interface interface-type interface-
number
184
Remarks
Repeat these steps to configure
one class for each SVLAN.
Required.
Repeat these steps to configure a
behavior for each CVLAN.
Required.
Required.
Repeat these steps to create other
CVLAN-to-SVLAN mappings.
Remarks
—
—
Required.
The default link type of an
Ethernet port is access.
Required.
By default, a trunk port is in only
VLAN 1.
Required.
By default, basic QinQ is
disabled.
Required.
Required.
Remarks
—
—