Displaying And Maintaining Super Vlan - HP 5820X series Configuration Manual

To do...
3. Configure the VLAN as a
super VLAN
4. Associate the super VLAN
with the specified sub-VLANs
Configure a VLAN interface for the super VLAN
To configure a VLAN interface for the super VLAN:
To do...
1. Enter system view
2. Create a VLAN interface, and
enter VLAN interface view
3. Configure the IP address of
the VLAN interface
4. Enable
local proxy
ARP
Configure the IP address of the VLAN interface with that of the corresponding super VLAN.
For more information about the local-proxy-arp enable command and the local proxy ARP function, see
the Layer 3—IP Services Configuration Guide.
You cannot configure a super VLAN as the guest VLAN for a port, and vice versa. For more information
about guest VLAN, see the Security Configuration Guide.
Configure Layer 2 multicast for a super VLAN. However, the configuration cannot take effect.
Configure DHCP, DHCPv6, Layer 3 multicast, and dynamic routing for the VLAN interface of a super
VLAN. However, only DHCP and DHCPv6 take effect.
Configuring VRRP for the VLAN interface of a super VLAN affects network performance. HP does not
recommend you to configure this function

Displaying and maintaining super VLAN

To do...
Display the mapping between a super
VLAN and its sub-VLANs
Use the command...
supervlan
subvlan vlan-list
Use the command...
system-view
interface vlan-interface vlan-
interface-id
ip address ip-address { mask |
mask-length } [ sub ]
ipv6 address { ipv6-address
{ prefix-length | link-local } |
ipv6-address/prefix-length
[ anycast | eui-64 ] | auto [ link-
local ] }
Enable local
local-proxy-arp enable
proxy ARP
Enable local
local-proxy-nd enable
proxy ND
Use the command...
display supervlan [ supervlan-id ] [ |
{ begin | exclude | include } regular-
expression ]
Remarks
Required.
Required.
VLANs specified by vlan-list must be
the sub-VLANs configured earlier.
Remarks
—
Required.
The value of vlan-interface-id must
be the ID of the super VLAN.
Required.
Use either command.
By default, the IP address of a
VLAN interface is not configured.
Required.
Use either command.
Disabled by default.
128
Remarks
Available in any view