Bottom-Side Components; Removing Bottom-Side Components - Arctic Cat Wildcar Trail Service Manual

Bottom-Side
Components
 NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to
be addressed and to service only those components.
The technician should use discretion and sound
judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine must be removed from the frame
for this procedure.
Removing Bottom-Side
Components
1. Remove the cap screws securing the PTO-side cover
to crankcase.
2. Using an appropriate puller if needed, remove the
PTO-side cover. Account for a gasket, two dowel pins,
and two longer fasteners for assembly purposes.
WT170A
3. Remove the chain by pulling it down through the
crankcase and out the PTO side.
4. Remove the fastener securing the chain guide to the
crankcase.
 NOTE: If the water pump does not require servicing,
it does not have to be removed.
5. Remove the cap screws securing the water pump
cover to the crankcase. Account for two dowel pins
and an O-ring.
6. Remove the cap screws securing the MAG-side cover
to the crankcase. Account for two dowel pins and dis-
card the gasket.
ROV1-045A
ROV1-048
ROV1-056A
ROV1-054A
59