Figure 12 Installing The Subassembly To The Mast With The Vaisala Clamp Assembly; Figure 13 Testing The Connector - Vaisala PWD22 User Manual

User's Guide _______________________________________________________________________
NOTE
CAUTION
44____________________________________________________________________ M210543EN-B
Figure 12 Installing the Subassembly to the Mast with the
Vaisala Clamp Assembly
2. Install the subassembly to the mast. See Figure 12 above.
Do not damage the RAINCAP
3. Connect the PWD22 mast cable (power and signal cable) to a
fixed connector underneath the PWD22 housing.
4. Test if the connector swings. If it swings, the mating surface of
the connector is not sealed and thus, it will leak. Also the
connector terminals will be exposed to weather.
Figure 13 Testing the Connector
Tighten the connector properly. The cable connector must not swing
in relation to the fixed connector.
®
plate.
0311-063
0308-004