Chapter 5__________________________________________________________________ Operation
NOTE
NOTE
VAISALA ________________________________________________________________________ 87
HEAT
This test command can be used to test the heater control relays and the
heating elements and power.
The following is an example of the command:
HEAT ON
When you want to stop the heater test and quit the test mode, press
ESC.
Do not leave the heater testing on in warm conditions for long periods
of time.
Other Commands
TIME
The TIME command is used for maintenance purposes. To display
the current system time, type the following:
TIME
The following is an example of the system output:
10:11:12
To set the time, use the following command:
TIME hh mm ss
where
hh =
hours
mm =
minutes
ss =
seconds
The time and date has to be reset after a power break. There is no
battery backup!