Vaisala PWD22 User Manual page 74

User's Guide _______________________________________________________________________
72____________________________________________________________________ M210543EN-B
- Unit id characters (2)
- References and limits for contamination monitoring
- Baud rate
- Serial number
- EEPROM checksum
- Relay control mode and Relay delays
- Analog output mode and range
- Hood heater usage
To prevent unauthorized change of the system parameters, a four-
character password can be set. If no password is set, the command
continues as if it had the correct password.
When no password has been set, the command is the following:
CONF
When a password has been set in a previous session, the command
format (max. four character string, printable characters) is the
following:
CONF password
If the previous password is known, the password can be changed with
the CONF password N command, where the N character stands for
new.
After getting the correct password, the system asks for a new
password. Press ENTER to remove the password. Otherwise, type a
new password.