Table of Contents
Advertisement
User's Guide _______________________________________________________________________
66____________________________________________________________________ M210543EN-B
MES
After opening the line for operator commands (see section Entering
and Exiting the Command Mode on page 56), a data message can be
displayed using the MES command. Refer to section Message Types
on page 57 for message type descriptions.
The command format is the following:
MES Message_number
The valid range is 0 ... 4 and 7.
For example, when choosing the data message number 0, type the
following:
>MES 0
AMES
The AMES command defines the message, which PWD22 transmits
as the automatic message or as the default polled message.
The AMES command format is the following:
AMES Message_number Message_interval
where
Message_number =
The valid range is 0 ... 4 and 7. Selects the
corresponding message. Any negative
message number is converted to 0. Message
number is also the default number for the
MES command and polling. There are four
messages, numbers from 0 to 3 available for
different uses. For message type descriptions,
refer to section Message Types on page 57.
Advertisement
Table of Contents
Troubleshooting
