Serial Interface (Rs-232) - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Serial interface (RS-232)

Use the micro USB connector for serial communication with SX10.
You need a micro USB to USB cable, and you may need to install
a serial port driver on the computer.
The serial connection can be used without an IP-address, DNS, or
a network.
Parameters:
• Baud rate: 115200 bps
• Data bits: 8
• Parity: None
• Stop bit: 1
Video system settings
Serial communication is enabled by default. Use the following
configuration to change the behavior:
SerialPort > Mode
For security reasons, you are asked to sign in before using the
serial interface. Use the following setting to change the behavior:
SerialPort > LoginRequired
Restart the video system when you have made changes to the
serial port settings.
D15330.02 SX10 Administrator Guide CE8.1, APRIL 2016.
Configuration Peripherals
Computer
Maintenance
USB
USB to micro USB cable
Micro USB connector
www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
134
Administrator Guide
System settings Appendices Appendices
Micro USB
Video
system
Lift the rubber flap
to get access to the
micro USB connector.