Siemens Simodrive 611 Configuration Manual page 330

02.07
05.01
S
VS1
U1
U2
V1
V2
U3
U4
VS3
VS1 +
K1
K3 +
VS3
Fig. 8-44 Connection of internal cable routing and VPM 200 Dynamik
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
Connection of internal cable routing and VPM 200 Dynamik
VS2
W1
PE1
X3
W2
PE2
W3
PE3
W4
PE4
VS4
VS2 +
K2
K4 +
VS4
8 Important Circuit Information
8.16 VPM Voltage Protection Module
Wiring sequence
S
Attaching the four cable glands
S
Strip cable to approx. 300 mm, based on the
cable glands you are using, and expose the
shield connection
S
Apply the cable lug
S
Connect the cables to X3 and secure them
with the cable tie (see Fig. 8-46)
S
Insert K1 and K2 into VS1 and VS2 and pull
taught, making sure that the black cable (L1)
and the protective cable are on top.
S
Connect the individual cables in the following
order:
K1 blue (L2) ⇒ V1
–
K2 blue (L2) ⇒ V1
–
K2 green/yellow (PE) ⇒ PE1
–
K1 brown (L3) ⇒ W2
–
K2 black (L1) ⇒ U2
–
S
For the time being, do not connect the
remaining three cables
S
Insert K3 and K4 into VS3 and VS4 and pull
tight, making sure that the black cable (L1)
and the protective cable are on top.
S
Connect the individual cables in the following
order:
K3 blue (L2) ⇒ V2
–
K4 blue (L2) ⇒ V2
–
K3 brown (L3) ⇒ W3
–
K4 green/yellow (PE) ⇒ PE4
–
K4 black (L1) ⇒ U3
–
K1 black (L1) ⇒ U4
–
K3 black (L1) ⇒ U1
–
K2 brown (L3) ⇒ W4
–
K4 brown (L3) ⇒ W1
–
K3 green/yellow (PE) ⇒ PE3
–
K1 green/yellow (PE) ⇒ PE2
–
Where:
K1: Cable 1 (from the converter)
K2: Cable 2 (from the converter)
K3: Cable 3 (from the motor)
K4: Cable 4 (from the motor)
VS1 to VS4: Cable glands 1 to 4
U1 to U4: Terminal studs 1 to 4, phase U
V1 and V2: Terminal studs 1 and 2, phase V
W1 to W4: Terminal studs 1 to 4, phase W
PE1 to PE4: Terminal studs 1 to 4, busbar PE
U: Busbar, phase U
V: Busbar, phase V
W: Busbar, phase W
PE: Busbar PE
8
8-329