Siemens Simodrive 611 Configuration Manual page 152

05.08
05.01
Table 6-2 Interface overview, 5 kW UI modules, continued
Term. Desig-
No. nation
111 X161
Signaling contact
213 X161
Line contactor
2)4)
9 X141B FR+
112 X141B Setup/normal operation
48 X141B Contactor control
NS1 X141B
Coil contact for
NS2 X141B
line supply, pre–charging
15 X141B M
contactor
1) I = input; O = output; NC = NC contact; NO = NO contact
2) Term. 19 is the reference ground (connected through 10 kW to the general reference ground X131 inside the module)
Terminal 15 must not be connected to PE, to terminal 19 or to external voltage sources
Terminal 19 can be connected to X131.
The terminal may be used exclusively for enabling the associated drive group.
3) The grounding clip is used to ground the DC link M busbar through 100 kΩ (must be closed;
the grounding clip must be opened if the system is subject to a high–voltage test).
4) max. current load of terminal 9 – terminal 19  1 A
Notice: For the 5 kW, there are no terminals 7, 45, 44 and 10.
5) RESET = resets the fault memory, edge–triggered for the complete drive group
(terminal "R" ! Term. 19 = RESET)
only use copper cables dimensioned for an operating temperature w 60°C.
:
6) For UL certification
7) In accordance with EN 60204–1 (machine safety),
control transformers must be used for AC control voltages.
Notice
There are no 7, 45, 44 and 10 terminals for the 5 kW UI module.
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
Type
Function
1)
I 1–ph. 250 V AC/50 V DC/2 A
NC 17 V DC/3 mA min
O +24 V
I +13 V...30 V/R
I +13 V...30 V/R
O +24 V
I 0/+24 V
O 0 V
6 Infeed Modules
6.2 Interface overview
Typ. voltage/limit values
7)
= 1.5 kΩ
E
= 1.5 kΩ
E
Max. cross–section
6)
2
1.5 mm
2
1.5 mm
max. cable length,
30 m
2
1.5 mm
2
1.5 mm
2
1.5 mm
2
1.5 mm
2
1.5 mm
2
1.5 mm
6-151
6