Connectable Cable Cross–Sections - Siemens Simodrive 611 Configuration Manual

10.04 02.12
05.01
5.6.2 Connectable cable cross–sections
The cable cross–sections that can be connected are listed in Table 5-7:
Table 5-7 Cable cross–sections that can be connected at the power module (motor connection)
MLFB
j
6SN112 –1AA00–0KAV 400 A
j
6SN112 –1AA00–0JAV 300 A
j
6SN112 –1AA01–0FAV 200 A
6SN1123–1AA02–0F AV 200 A
6SN112V–1AA00–0EAV 160 A
6SN112V–1AA00–0LAV 108 A
6SN1123–1AA00–0DAV 80 A
6SN112V–1AA00–0CAV 50 A
6SN112V–1AA00–0BAV 25 A
6SN112V–1AA00–0AAV 15 A
6SN112V–1AA00–0HAV
6SN112V–1AB00–0CAV 2x50 A
6SN1123–1AB00–0BAV 2x25 A
j
6SN112 –1AB00–0AAV 2x15 A
6SN1123–1AB00–0HAV 2x8 A
Key
X
1) Size of the screw for the protective conductor connection
2) Tightening torque of the terminals or connectors
Warning
!
The internal overload monitoring function of the power modules only protects
the cable if this is dimensioned/selected corresponding to the power module
currents. If smaller cross–sections are selected, then the user must ensure the
appropriate level of cable protection, e.g. by suitably setting the control
parameters.
Note
For UL certification, only use copper cables that have been appropriately
dimensioned/selected for the operating temperature w60 _C.
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
Connection cross–section [mm
1,5 2,5 4 6 10 16 25 35 50 70 95 120 150
X
X X X X
X X X X
X X X X
8 A X X X X
X X X X
X X X X
X X X X
X X X X
Terminal area for flexible cable with end sleeves (with or without plastic collars)
Terminal area for flexible cables with terminal pin
IP20 is guaranteed when correctly used, e.g. insulated pin–type cable lugs
5 Power Modules
5.6 Interfaces and terminals
2
] 1)
X M6
X M6
X M6
X M6
X M6
X M6
M5
M5
M5
M5
M5
M5
M5
M5
M5
2)
[Nm]
25...30
5
15...20
15...20
15...20
6...8
6...8
1,5...1,8
0,7...0,8
0,7...0,8
0,7...0,8
0,7...0,8
0,7...0,8
0,7...0,8
0,7...0,8
0,7...0,8
5-137