Target Computer Setup - Lantronix SecureLinx Spider User Manual

3. Upon bootup, the terminal window displays the login prompt. To change the default
IP auto configuration from DHCP to a static IP address, type config and press
Enter.
4. At the IP autoconfiguration prompt, type none and press Enter.
5. Follow the prompts to enter the unit's IP address, subnet mask, default gateway, and
LAN interface information.
6. Type Y, following by Enter, to accept the changes. The system takes several
seconds to update the internal protocol stack and display the updated information.
7. Plug an Ethernet cable connected to your network into the Ethernet port. The Link
LED illuminates.

Target computer setup

Video
The Spider recognizes a wide variety of VESA, Sun, and Apple video resolutions up to a
maximum of 1280x1024@60Hz; the complete list of supported video formats is found in
B:Supported Video
attached Spider, set the monitored server's video resolution to the minimum necessary
for your remote monitoring application.
1024x768 is recommended or 800x600 if connecting the Spider over a wide area network
rather than a LAN.1280x1024 may be used for applications demanding higher resolution,
however it consumes more network bandwidth. The other supported formats are
recognized by the Spider, but may offer difficulty if the timing does not comply with the
applicable standard. The Spider supports the extended display identification data (EDID)
standard for informing the attached computer of its supported video formats.
On a Windows target system, select Control Panel Display Settings. Modify the
screen resolution value as necessary.
Select Control Panel Display Settings Advanced Monitor. Modify the screen
refresh rate (consult the appropriate documentation when using an atypical video card
or another operating system on the target computer).
SecureLinx Spider User Guide
Formats. In order to minimize power consumed in the server and
3: Installation
14