Installation And Network Settings - Lantronix SecureLinx Spider User Manual

Installation and Network Settings

Auxiliary Power
Connector (for
optional power cable)
RJ45 Ethernet Port
1. Plug the RJ45 end of the included serial cable into the Spider's serial port. Plug the
DB9F end into the serial (COM) port of a PC/laptop running a terminal emulation (e.g.
HyperTerminal). The default serial port settings are 115200 bits per second, 8 data
bits, no parity, 1 stop bit, no flow control.
2. The Spider is typically powered by the attached server. Plug the Spider video, USB,
and PS/2 keyboard/mouse (if applicable) cables into the target computer (this is
required for the device to boot up). The two blue power LEDs will illuminate and the
green system OK LED flashes to indicate that it is booting up. Bootup is complete
within approximately one minute. The system OK LED stops flashing and remains
illuminated.
SecureLinx Spider User Guide
Figure 2 Serial and Auxiliary Power Port
Figure 3 Ethernet and Cascade Ports
Table 3-1 Indicator LEDs
Pwr1 Blue Power Good indicates adequate power from source 1 (USB1)
Pwr2 Blue Power Good indicates adequate power from source 2 (USB2 or
PS/2)
SysOK Green Blinks upon bootup. Steady when up and healthy
Video Green Video is coming from target server (Vsync present)
Unit ID Orange Optionally lit to assist in finding unit
RS-232 Pinouts
1
2
3
4
5
6
7
RS-232 Serial Port
RJ45 Cascade Port
3: Installation
RTS (out)
DTR (out)
TX (out)
GND
GND
RX (in)
DSR (in)
13