Setting Ptz Presets, Patrols & Patterns; Customizing Presets; Calling Presets - Nuvico HDoCS DT_E/P Instruction Manual

Table of Contents

4.2 Setting PTZ Presets, Patrols & Patterns

Before you start:

Please make sure that the presets, patrols and patterns should be supported by PTZ protocols.

Purpose:

Follow the steps to set the Preset location which you want the PTZ camera to point to when an event takes

place.

Steps:

1. Enter the PTZ Control interface.

Menu>Camera>PTZ

2. Use the directional button to wheel the camera to the location where you want to set preset; and the zoom

and focus operations can be recorded in the preset as well.

3. Enter the preset No. (1~255) in the preset text field, and click the Set button to link the location to the

preset.

Repeat the steps2-3 to save more presets.

You can click the Clear button to clear the location information of the preset, or click the Clear All button

to clear the location information of all the presets.

This feature enables the camera to point to a specified position such as a window when an event takes place.

Steps:

1. Click the button PTZ in the lower-right corner of the PTZ setting interface;

Or press the PTZ button on the front panel or click the PTZ Control icon

select the PTZ option in the right-click menu to show the PTZ control panel.

2. Choose Camera in the dropdown list.

3. Click the

button to show the general settings of the PTZ control.

4. Click to enter the preset No. in the corresponding text field.

5. Click the Call Preset button to call it.

NOTE

When the Coaxitron camera/dome connected and the PTZ protocol is selected to ) or PELCO-C

(Coaxitron), you can call the preset 95 to enter the menu of the connected Coaxitron camera/dome. Use the

directional buttons on the PTZ control panel to operate the menu.

in the quick setting bar, or

Table of Contents